ACT ACT-120125 Switching Power Supply Waterproof for RevSci IncuFridge RS-IF-253

ACT ACT-120125 Waterproof Switching Power Supply (12V DC, 12.5A, 150W) for RevSci IncuFridge RS-IF-253. A heavy-duty, sealed AC/DC constant-voltage power converter engineered to provide high-current, low-ripple direct current to drive the solid-state Peltier thermoelectric engine and circulation fans in the RevSci IncuFridge 53L chilling incubator.

• MPN / Model: ACT-120125 (ACT Industrial / Laboratory Power Line)
• Manufacturer & Application Line: ACT / Dedicated OEM Replacement Power Supply for Revolutionary Science IncuFridge Subsystems
• Target System Compatibility: Specifically designed as the primary internal DC power supply for Revolutionary Science IncuFridge 53-Liter Chilling/Refrigerated Incubators (Model RS-IF-253 and RS-IF-253Pro series)
• Electrical Input Ratings: Universal wide-range AC input spanning 100–240 VAC, 50/60 Hz, accommodating domestic and international mains power fluctuations without dropouts
• Electrical Output Ratings: Constant 12V DC nominal output delivering up to 12.5 Amps continuous current (150 Watts maximum power output), sized to handle high initial inrush and steady-state thermal loads
• Waterproof & Ingress Protection: Fully potted and encapsulated IP67-rated waterproof / moisture-resistant aluminum housing, engineered to prevent internal shorts, corrosion, or creepage degradation from incubator condensation, humidity, and chemical vapor exposure
• Thermal Dissipation & Enclosure: Extruded aluminum alloy chassis functioning as an integrated conduction heat sink for passive, silent convection cooling; eliminates internal cooling fans to prevent dust ingestion and mechanical failure
• Built-In Circuit Protections: Comprehensive automatic-recovery protection suite, including Over-Current Protection (OCP), Over-Voltage Protection (OVP), Short-Circuit Protection (SCP / Hiccup mode), and Over-Temperature Protection (OTP)
• Wiring & Connections: Heavy-gauge, double-insulated flying wire leads (pre-stripped and tinned) for line (L), neutral (N), ground (G), and dual positive (+12V) / negative (-12V) DC outputs for straightforward hardwiring into the incubator's terminal blocks
• Primary Application: Main power conversion supplying the Peltier thermoelectric cooling block, hot/cold heat sink exhaust fans, internal chamber air circulation blowers, and digital LCD control electronics in BOD testing, enzyme storage, and microbiological incubation protocols